Arduino UNO - R3 with USB Cable



New product

  • Microcontroller ATmega328 (PDIP)
  • Operating Voltage 5V
  • Input Voltage (limits) 6-20V
  • Analog Input Pins 6
  • Flash Memory 32 KB (ATmega328) of which 0.5 KB used by bootloader

More details

10 Items

INR 999.00 tax excl.

Arduino UNO - R3 with USB Cable includes both Arduino Uno board and compatible USB Cable. Arduino UNO - R3 is a microcontroller board based on the ATmega328. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz ceramic resonator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable & start innovating.

Arduino UNO - R3 differs from all preceding boards in that it does not use the FTDI USB-to-serial driver chip. Instead, it features the Atmega16U2 (Atmega8U2 up to version R2) programmed as a USB-to-serial converter. Revision 2 of Arduino UNO has a resistor pulling the 8U2 HWB line to ground, making it easier to put into DFU mode. Revision 3, Arduino UNO - R3 has the following new features:

  • 1.0 pinout: added SDA and SCL pins that are near to the AREF pin and two other new pins placed near to the RESET pin, the IOREF that allow the shields to adapt to the voltage provided from the board. In future, shields will be compatible with both the board that uses the AVR, which operates with 5V and with the Arduino Due that operates with 3.3V. The second one is a not connected pin, that is reserved for future purposes.
  • Stronger RESET circuit
  • Atmega 16U2 replaces 8U2.

"UNO" means one in Italian and is named to mark the upcoming release of Arduino 1.0. The Uno and version 1.0 will be the reference versions of Arduino, moving forward. The Uno is the latest in a series of USB Arduino boards, and the reference model for the Arduino platform.

Arduino UNO - R3 Features:

  • Microcontroller ATmega328 (PDIP)
  • Operating Voltage 5V
  • Input Voltage (recommended) 7-12V
  • Input Voltage (limits) 6-20V
  • Digital I/O Pins 14 (of which 6 provide PWM output)
  • Analog Input Pins 6
  • DC Current per I/O Pin 40 mA
  • DC Current for 3.3V Pin 50 mA
  • Flash Memory 32 KB (ATmega328) of which 0.5 KB used by bootloader
  • SRAM 2 KB (ATmega328)
  • EEPROM 1 KB (ATmega328)
  • Clock Speed 16 MHz

Arduino UNO - R3 Dimensions:

  • Length: 2.7"
  • Width: 2.1"

Write a review

30 other products in the same category:

Seller Detail