Line Follower Robotics Kit



New product

Multipurpose robot including motor shield and ir sensors presents

Multipurpose DIY kit Robohaat robotics development board based on atmega8.

Robot chassis is designed to be used with Arduino and BO motors.

More details

28 Items

INR 850.00

Description :

Kit includes - ( 12 pcs) - 1 set.

Robohaat motor shield - 1 no.

The L293D Motor Shield is a very useful shield with standard components. It contains two L293D motor drivers and one 74HC595 shift register. The shift register expands 3 pins of the Arduino to 8 pins to control the direction for the motor drivers. The output enable of the L293D is directly connected to PWM outputs of the Arduino. 2 connections for 5V 'hobby' servos connected to the Arduino's high-resolution dedicated timer

Robohaat ir sensor - 2 nos.

This is a multipurpose infrared sensor which can be used for obstacle sensing, line sensing, etc. and also as an encoder sensor. The sensor provides a digital output. The sensor outputs a logic one (+3.5V) at the digital output when an object is placed in front of the sensor and logic zero (0V), when there is no object in front of the sensor. An onboard LED is used to indicate the presence of an object. This IR proximity or obstacle sensor is designed to work with almost all Arduino boards and microcontrollers - AVR, PIC, 8051, ARM

Bo motors -2 nos.

Single Shaft Plastic Gear Motor - BO series L Shape motor gives good torque and rpm at lower operating voltages, which is the biggest advantage of these motors. Small shaft with matching wheels give optimized design for your application or robot. Mounting holes on the body & light weight makes it suitable for in-circuit placement.

Bo motor wheels - 2 nos.

7.2 cm BO wheel is suitable for Bo motor provide help in motion of the robot

Metal castor wheels - 2 nos. 

Castor wheel help to rotate or in changing direction when instruction is given or sense obstacles.

F to F jumper - 6 nos.

These premium jumper wires are good to wire harness or jumpering between headers on PCB's. These premium jumper wires are 8" (20cm) long. They have 0.1" female header contacts on either end and fit cleanly next to each other on standard-pitch 0.1" (2.54mm) header.

Nut bolts

Used for set all the component on the Chassis

  • Bo motor mounting nuts bolts - 2 sets
  • Wheel screw - 2 nos.
  • Sensor nuts and bolts - 8 sets
  • Plastic studs - 4 nos.
  • Nut bolt for battery holder - 2 sets
  • Nut bolt for castor wheel - 6 nos.
  • 6 X aa battery holder - 1 no.


The product works satisfactorily


Learning kit

can be assembled easily

Write your review!

Write a review

30 other products in the same category:

Seller Detail