New line-follower-kit-using-arduino

Line follower DIY kit using Arduino

HAPL

Ro-200

New product

This line follower kit is made using Arduino Uno board and is a very easy method to learn Arduino Programming and getting correct exposure to the Programming Platform.

More details

20 Items

INR 1,400.00

This kit is for all robotics enthusiasts starting from beginner level to expert level at economical cost.

It comes along with an Arduino Uno board, motor driver L298N, IR sensor module, DC geared motor, robot chassis, caster wheel, nut-bolt pack and a screw driver.

The chassis of Robot is metallic and easy to assemble.

Fully functional Line follower robot assemble in less than 30minutes. 

Kit includes - 1 set.

Arduino - 1no.

The Arduino Uno is a microcontroller board based on the ATmega328.
It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs
a 16 MHz ceramic resonator
a USB connection
a power jack
an ICSP header
and a reset button. 

Robohaat L239D motor shield - 1 no.

The L293D Motor Shield is a very useful shield with standard components. It contains two L293D motor drivers and one 74HC595 shift register. The shift register expands 3 pins of the Arduino to 8 pins to control the direction for the motor drivers. The output enable of the L293D is directly connected to PWM outputs of the Arduino. 2 connections for 5V 'hobby' servos connected to the Arduino's high-resolution dedicated timer

Robohaat IR sensor - 2 nos.

This is a multipurpose infrared sensor which can be used for obstacle sensing, line sensing, etc. and also as an encoder sensor. The sensor provides a digital output. The sensor outputs a logic one (+3.5V) at the digital output when an object is placed in front of the sensor and logic zero (0V), when there is no object in front of the sensor. An onboard LED is used to indicate the presence of an object. This IR proximity or obstacle sensor is designed to work with almost all Arduino boards and microcontrollers - AVR, PIC, 8051, ARM

Bo motors -4 nos.

Single Shaft Plastic Gear Motor - BO series L Shape motor gives good torque and rpm at lower operating voltages, which is the biggest advantage of these motors. Small shaft with matching wheels give optimized design for your application or robot. Mounting holes on the body & light weight makes it suitable for in-circuit placement.

Bo motor wheels - 4 nos.

7.2 cm BO wheel is suitable for Bo motor provide help in motion of the robot

F to F jumper - 6 nos.

These premium jumper wires are good to wire harness or jumpering between headers on PCB's. These premium jumper wires are 8" (20cm) long. They have 0.1" female header contacts on either end and fit cleanly next to each other on standard-pitch 0.1" (2.54mm) header.

Nut bolts

Used for set all the component on the Chassis

  • Bo motor mounting nuts bolts - 2 sets
  • Wheel screw - 2 nos.
  • Sensor nuts and bolts - 8 sets
  • Nut bolt for battery holder - 2 sets
  • 6 X aa battery holder - 1 no.
Grade 
08/31/2017

time saving

Best in categories... saved lot of my time.

Write your review!

Write a review

30 other products in the same category:

Seller Detail

Rishu
developerhapl@gmail.com
9555856868